Owner`s manual

93
11. Appendix
Infrastructure Mode:
When selecting LAN5 (factory default setting)
Check each item below in the Wireless Setting menu of the projector as follows:
*IP Address ..................No setting is required.
*Sub net ......................Should be same as the setting of the access point
*Gateway......................Should be same as the setting of the access point
*Network Type ............Should be the Infrastructure mode
*ESSID/SSID/IBSSID....Should be same as the setting of the access point
Check the settings for projector Client computer
*IP Address ..................No setting is required. Automatically set as HDCP.
*Wireless Channel........Should be 11
*ESSID/SSID/IBSSID....Is same as the setting of the access point?
*WEP............................Should be disabled.
->To enable the function, set the WEP by the browser after the
connection is established.(Refer to 6. Configurations with
Browser (p47). )
* When using LAN5, it is necessary DHCP/BOOTP server is under the environment enabling
those servers communicate through networks. Some access points may have the DHCP
function. For detail of the settings, refer to the owner's manual for the devices or consult a
system administrator of the network.
Is the segment where the projector is installed different from the computer?
Specify IP Address directly on the optional setting. Refer to "4. Wired LAN Configuration" ➔
"Confirming the Operation" (p28, 29).
■ Connection between computer and the projector via Wired LAN cannot be
established.
When selecting LAN1 (factory default setting)
Check IP address, Sub net and Gateway of the projector and computer. For further details of
the configuration, contact your system administrator.
Is the segment where the projector is installed different from the projector?
Specify IP Address directly on the optional setting. Refer to "4. Wired LAN Configuration" ➔
"Confirming the Operation" (p28, 29).
About Settings for LAN Environment:
When setting LAN4 or LAN5, first, connect to the projector with easy settings and set with
the browser. Or connect client computer to the projector in accordance with the factory
default settings. Make detailed settings by the browser and then restore the computer for
previous environment setting.
English