Owner`s manual
Table Of Contents
- Compliance
- Safety Instructions
- Table of Contents
- Operating Environment and Co...
- Required Operating Environme...
- Network Specifications of th...
- 1. About LAN Functions
- LAN Functions and the Features
- Image Projecting System via LAN
- Flow of Image Transfer
- An Example of the Connection
- LAN Connection Modes
- 2. Setup Procedures
- Installing the Software
- 3. Names and Functions of t
- Operation Screen.
- Network Connection Standby D...
- NetworkModule Client
- NetworkModule Moderator
- 4. Wired LAN Configurations
- Connecting to the LAN Line
- Network Environment Settings
- Setting Procedure
- Confirming the Operation
- User PIN C
- Wired Informati
- Wired Factory Default
- Factory Default Setting of t...
- 5. Wireless LAN Configurations
- Attaching the USB Wireless L...
- Setting the Network Environment
- Setting Procedures
- Easy Setting
- Setting Procedures
- User PIN C
- Wireless Informat
- Wireless Factory Default
- Wireless LAN Factory Default...
- 6. Configurations with Browser
- Introduction
- Browser Environment
- Browser Configuration
- Starting up the Browser
- Information
- Quick Setup
- Advanced Settings
- TCP / IP
- Wireless Setting
- Admin Password
- User PIN code
- Moderator Login Password
- Miscellaneous
- Change Configuration Set
- Restart
- 7. Project the Image via the...
- 8. Use the Moderator Function
- Moderator Function
- Preparation for Using the Mo...
- Preparation Procedure for Us...
- Setting the Moderator Function
- Registration of the Moderator
- Clients (Participants)
- Unregister from Moderator St...
- How to Use the Moderator Fun...
- Project the Client's Images
- Stop Projecting the Client's...
- Easy Settings for Moderator ...
- 9. How to Use Network Viewer
- The Mechanism of Network Vie...
- Operation
- Functional Conditions of FTP...
- Projecting the Image
- 10. How to Use the PJ Contro...
- How to Operate
- Initial Settings
- E-mail Setting
- Power & Status
- Control
- Multi Control
- 11. Appendix
- Troubleshooting
- Terminology
- Setting up the IP address wi...
78
Power & Status
Click "Power & Status" on the main menu and configure each item.
1. Turning on/off the projector
Click Standby / ON buttons. When clicking the Standby button, the confirmation message
will appear. Click OK to turn off the projector.
CAUTION: Projector cannot be turned on for approximately 90 seconds after it being turned off. When
the display of "Power Status" changes from " On cooling down" to " On", click ON to turn on the
projector.
Caution about turning on / off the projector via the networks
When you wish to turn on / off the projector via the networks, preset the projector as follows:
1. Select "Setting" from the Projector menu.
2. Select "Standby mode" from the Setting menu and set it as "Normal".
If you set this function as Normal, the network part of the projector is constantly provided
with power even if the projector is turned off. If you set this as Eco, then the network part
will be turned off when you turn off the projector. Consequently, you cannot turn on / off
the projector via the networks.
10. How to Use the PJ Controller