Owner`s manual

47
6. Configurations with Browser
Wireless related items can be configured
on this screen.
This screen will not be displayed at Wired
LAN setting.
Parameter Description
Wireless Mode ................................Select the Communication standard 802.11b or 802.11b.g
Network Type....................................Select either “Infrastructure” or “AdHoc”.
SSID* ..............................................Set the SSID/ESSID. (up to ASCII 32 characters)
SSID/ESSID is case-sensitive. Even though all characters on the
Wireless information is uppercase, it is necessary to distinguish
between upper case and lower case characters.
Channel................................................If you use the projector in 802.11AdHoc mode, select the channel, from 1 to
11.
WEP Security ..................................Select "Enable" or "Disable" the WEP(encryption).
When using WEP, select any of following items corresponding to this
WEP; "Enable 40-bit", "Enable 104-bit", "Enable 128-bit" and "Enable
(802.1x"LEAP")"
When enabling WEP (Encryption), the image transfer speed may become
slower.
WEP Key#1- Key#4 ........................Set WEP key in the hexadecimal notation (0 to F). 5 bytes are set for 40-
bit WEP, 13 bytes are set for 104-bit, and 16 bytes are set for 128-bit
WEP. Four WEP keys can be set, however, the only one with check on
its radio button is in effect. Both of the number and value of the WEP
key in effect must be same as those of your computer and the access
point.
Depending on computers and access points, you may be allowed to
select only one WEP key. In this case, use WEP key 1.
LEAP Username / Password ..........When selecting 802.1 x "LEAP" in WEP security, enter the user name
and the password. Enter with ASCII 64-byte capital characters and one-
byte characters. Consult your system administrator about the user
name and the password.
APPLY button ..................................Click the APPLY button to update. The screen to restart the projector will be
displayed.
REFRESH button ............................Update and show the adjusted data.
RESTORE Factory Default Settings button....Restore the Wireless Settings to the values at the factory.
Wireless Setting
English