Owner`s manual
Table Of Contents
- Compliance
- Safety Instructions
- Table of Contents
- Operating Environment and Co...
- Required Operating Environme...
- Network Specifications of th...
- 1. About LAN Functions
- LAN Functions and the Features
- Image Projecting System via LAN
- Flow of Image Transfer
- An Example of the Connection
- LAN Connection Modes
- 2. Setup Procedures
- Installing the Software
- 3. Names and Functions of t
- Operation Screen.
- Network Connection Standby D...
- NetworkModule Client
- NetworkModule Moderator
- 4. Wired LAN Configurations
- Connecting to the LAN Line
- Network Environment Settings
- Setting Procedure
- Confirming the Operation
- User PIN C
- Wired Informati
- Wired Factory Default
- Factory Default Setting of t...
- 5. Wireless LAN Configurations
- Attaching the USB Wireless L...
- Setting the Network Environment
- Setting Procedures
- Easy Setting
- Setting Procedures
- User PIN C
- Wireless Informat
- Wireless Factory Default
- Wireless LAN Factory Default...
- 6. Configurations with Browser
- Introduction
- Browser Environment
- Browser Configuration
- Starting up the Browser
- Information
- Quick Setup
- Advanced Settings
- TCP / IP
- Wireless Setting
- Admin Password
- User PIN code
- Moderator Login Password
- Miscellaneous
- Change Configuration Set
- Restart
- 7. Project the Image via the...
- 8. Use the Moderator Function
- Moderator Function
- Preparation for Using the Mo...
- Preparation Procedure for Us...
- Setting the Moderator Function
- Registration of the Moderator
- Clients (Participants)
- Unregister from Moderator St...
- How to Use the Moderator Fun...
- Project the Client's Images
- Stop Projecting the Client's...
- Easy Settings for Moderator ...
- 9. How to Use Network Viewer
- The Mechanism of Network Vie...
- Operation
- Functional Conditions of FTP...
- Projecting the Image
- 10. How to Use the PJ Contro...
- How to Operate
- Initial Settings
- E-mail Setting
- Power & Status
- Control
- Multi Control
- 11. Appendix
- Troubleshooting
- Terminology
- Setting up the IP address wi...
28
4. Wired LAN Configurations
NetworkModule Client screen Error screen
Confirming the Operation
Confirm that the projector has connected to the LAN properly.
1. Activate "NetworkModule Client" or "NetworkModule Moderator" which is installed into the
computer connected to the LAN .
2. After appearing "NetworkModule searching" message, the name of the projector* appears on
the Network Projector List, then the network setting has completed properly.
When the name of the projector does not appear and error screen appears, the network has
not connected yet. Try searching again with the Refresh List button. If error screen appears
again, reconfirm the LAN setting. When the projector is set where separated by the router,
see next page.
When Firewall function (Anti-virus software) is effective, network projector may not be found.
In that case, disable the Firewall function and try searching again.
✳ If the projector is named, the name will be displayed. The name can be set with following the
procedures in "6. Configurations with Browser" ➔ "Quick Setup" (p44-45) or "Advanced
Settings" ➔ "Miscellaneous" (p52). If the projector is not named, MAC address of the
projector will be displayed.
Refresh List button Network Projector List