Owner`s manual

Compliance
For Canadian Users
This Class B digital apparatus complies with Canadian ICES-003.
Cet apparei numérique de la class B est conforme à la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de
brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même
si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.
CAUTION
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate the equipment.
Exposure to radio frequency
This product uses an optionally available USB Wireless LAN Adapter (XG-705A) to communicate with other
devices using the 2.4 GHz ISM band. The radiated power output of this card is well below FCC radio
frequency exposure limits. However, it is advised to maintain a minimum 20 cm separation between the
product and user(s) or bystanders to minimize human exposure to the transmitted radio frequencies.
For French Users
Restricted frequency band only channels 10 through 11 (2457MHz and 2462MHz respectively) may be used
in France. License required for every installation, indoor and outdoor installations.
Please contact ART for procedure to follow. Do not use this USB Wireless LAN Adapter in the open air.
Statement on EC Directive
Hereby, Eiki Co., Ltd., declares that this Wireless USB LAN Adapter (XG-705A) is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
Federal Communication Commission Notice
Note : This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures :
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If
such changes or modifications should be made, you could be required to stop operation of the equipment.
Model Number : XG-705A
Trade Name : EIKI
Responsible party : EIKI International, Inc.
Address : 30251 Esperanza Rancho Santa Margarita CA 92688-2132
Telephone No. : 800-242-3454 (949-457-0200)
The CE Mark is a Directive conformity mark of
the European Community(EC).
The Alert Mark is a Directive conformity mark
of the European Community.
2