Eiki A-3 Movement sensor Instruction Manual Package contents Item Movement sensor Manual Qty.
V:E1.01 To the InstallerR Thank you for choosing Eiki A-3. Mounting The A-3 uses passive infra-red technology to detect movement in a room. It is intended to be used with the Eiki range of control systems to automatically shut down equipment in the room after a period of time when no movement is detected, so saving energy and maximising projector lamp life.
Wiring Testing Connect the terminals as shown in the diagram to the control panel or access port. With the cover fitted, apply power and wait at least 30 seconds. After this time, if there is no movement, the LED should go out. Once this has happened, any movement should cause a couple of rapid flickers and the LED should lock on for about 5 seconds. You do not need to connect the tamper switch terminals. GND +12v Sensor Walk around the room and check that your movement can be reliably detected.
U.S.A. Canada EIKI International, Inc. 30251 Esperanza Rancho Santa Margarita CA 92688-2132 U.S.A. Tel : 800-242-3454 (949)-457-0200 Fax : 800-457-3454 (949)-457-7878 E-Mail : usa@eiki.com EIKI CANADA - Eiki International, Inc. P.O. Box 156, 310 First St. - Unit 2, Midland, ON, L4R 4K8, Canada Tel : 800-563-3454 (705)-527-4084 Fax : 800-567-4069 (705)-527-4087 E-Mail : canada@eiki.
