Owner`s manual

62
10. PJ Controller
Preparation
1. Start up the MCI Client
To activate the MCI Client, select [Start] > [Program] > [Multi Card Imager] > [MCI Client] in
that order. Detected projectors will be displayed on the main screen.
✐ Connecting the projector separated by a rooter✐
MCI Client computer cannot connect to the projector installed in the segment beyond the rooter
cannot be connected.
In this case, click Options button to show the Options Screen.
q Click Add button to display the IP Address Screen.
w Enter the same IP address as the one set to the projector. (e.g. 192.168.100.100)
e Click OK button to close the window. The entered IP address will be added to the
Known Devices List.
Options button
Enter the IP address
The entered IP address will be
shown here.