Quick Start Guide

- 19 -
English
Turn off the projector and unplug the AC power cord. Let
the projector cool for at least 45 minutes.
Loosen the screw and open the lamp cover. Pull out the
lamp by using the built in handle.
1
3
Replace the lamp with a new one. Make sure that the
lamp is properly and fully inserted.
4
Open the filter cover.
2
Connect the AC power cord to the projector and turn on
the projector.
6
Follow these steps to replace the lamp.
Reset the Lamp counter.
See “Resetting the Lamp Counter” in the owner’s
manual (CD-ROM).
5
✔Note:
• Be sure to insert the lamp in the correct direction.
• Do not reset the Lamp counter when the projection lamp is
not replaced.
Lamp Replacement
For continued safety, replace with a lamp of the
same type. Do not drop the lamp or touch the
glass bulb! The glass can shatter and may cause
injury.
Allow a projector to cool for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
CAUTION
CAUTION
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the
screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing
when the LAMP REPLACE indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
Lamp replacement icon
7
Close the lamp cover and secure the screw.
8
Close the filter cover.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer.
When ordering, give the following information to the dealer.
● Model No. of your projector
LC-X85
● Replacement Lamp Type No.
POA-LMP124
(Service Parts No. 610 341 1941)
Lamp
Handle
Lamp cover
Filter cover
Screw
KR7BL-A_quick.indb 19KR7BL-A_quick.indb 19 09.8.27 2:34:24 PM09.8.27 2:34:24 PM