Owner`s manual
Table Of Contents
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
- EIKI EIP-UHS100+XHS100 UM_20141027 - P1~50.pdf
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
63
Open a web browser on your PC and type the IP address of the projector
(192.168.0.100), IP conguration will be shown on the web page.
Set the IP address and subnet mask and click SAVE to confirm the configuration.
Projector Web Control will show below message for conrmation.
“The projector IP will be changed and the connection to the projector will be lost, do you
want to continue ?
Select "Yes" to conrm the changes, "No" to cancel.
Note:
Mark sure the IP address of the projector and PC are in the same network group.
Using Projector Web Control
Control
Source/General
Use this page to control the general settings of the projector such as power on/off,
source….etc.
NotethatifprojectorcontroloptionisselectedtoRS232,thewebcontrolwillbeinterrupt.Networkcontrol
has to be enabled from the projector’s OSD menu before connecting to projector web control.