Owner`s manual
Table Of Contents
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
- EIKI EIP-UHS100+XHS100 UM_20141027 - P1~50.pdf
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
62
Projector Control via LAN
The projector supports to control the projector through the network. Before using this
function, please set up the network conguration of your personal computer.
1. Set up network conguration.
The default IP address of the projector is 192.168.0.100, please follow below steps to
set the network conguration.
Connect RJ-45 cable from PC to the LAN connector on the projector.
IN OUT
TEJ
HV
RGBLAN
RS-232
HDMI
DVI-DB/PbG/Y R/Pr
WIRED REMOTE
TRIGGER
2. Set up Internet Protocol (TCP/IP) Properties in your PC as below:
Recommended PC setting
IP Address : 192.168.0. 99.
Subnet : 255.255.255.0
Default settings for the projector
IP Address : 192.168.0.100
Subnet : 255.255.255.0