Owner`s manual

61
Serial Control Interface
This projector provides a function to control and monitor the projector's operations by
using the RS-232C serial terminal.
Setup the Communication Condition
You can use the serial control command to input commands for projector control or
retrieve its operational data through Windows client terminal software, e.g. Hyper Terminal.
Before using the software to control the projector, please set up below communication
conditions in the software.
Item Parameter
Baud Rate 115200 (default), 57600, 38400, 19200, 14400, 9600, 4800, 2400, 1200bps
Data Bit 8
Parity Check None
Stop Bit 1
Flow Control None
Note:
The default of the baud rate is 115200 bps. If an error occurs in the communication, change the serial port
andthecommunicationspeed(baudrate).
The serial control is not available if Eco Network Power is set to Eco or Projector Control is set to Network,
pleasemarksureECONetworkPowerissettoStandard,andProjectorcontrolissettoRS-232.