Owner`s manual
Table Of Contents
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
- EIKI EIP-UHS100+XHS100 UM_20141027 - P1~50.pdf
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
57
Warning Indicators
SHUTTER
TEMP.
LAMP 2
LAMP 1
POWER
STATUS
Power LED
LED Projector status Procedure
Off Power is off
Flashing Green Prepare to turn of projector Wait till projector start displaying
Orange Projector cooling Wait until cooling nish (90 sec)
On Red Standby mode
Green Projector is on
Status LED
LED Display Projector status Procedure
Off No Problem
Flashing Red (Cycles of 1) Cover Problem Contact local EIKI Service Center
Red (Cycles of 4) Fan Problem Contact local EIKI Service Center
On Red System Error Contact local EIKI Service Center
Lamp 1 / Lamp 2 LED
LED Display Projector status Procedure
Off Lamp off
Flashing Green Prepare to light lamp
Red (Cycles of 6) Lamp lit fail
On Red Lamp is end-of-life It is recommended to change
the Lamp. Contact local EIKI
Service Center and ask an
advice.
Green Lamp lit
Temp LED
LED Display Projector status Procedure
Off No Problem
Flashing Red Temperature problem Contact local EIKI Service Center
Shutter LED
LED Display Projector status Procedure
Off Shutter is open
On Green Shutter is closed