Owner`s manual
Table Of Contents
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
- EIKI EIP-UHS100+XHS100 UM_20141027 - P1~50.pdf
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
51
Maintenance and Care
Lamp Replacement
The lifecycle of ordinary projection lamp typically lasts for 2000 hours before requiring
replacement (different lamp congurations will affect lamp life). From the OSD Menu, you
can check how long the lamp has been used. You should also replace the lamp when the
projected image gets noticeably darker. Contact your local dealer to purchase new certied
lamps.
To replace the projector lamp
1. Turn off the projector and unplug the power cord. Leave the projector for approximately
60 minutes to cool enough before removing the lamp module for replacement.
Note:
Whenyouturnofftheprojector,thelampinsidetheprojectorwillstillbeveryhot(200-300°C).Ifyouattempt
to replace the lamp without allowing the projector to cool, you could risk scalding yourself. That is why you
should wait for the lamp to cool down in order to perform the replacement safely.
2. Loosen the screws and remove the fan unit.
3. Loosen the screws and pull the lamp module out
.
Lamp 1
Lamp
2
Lamp 2