Owner`s manual
Table Of Contents
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
- EIKI EIP-UHS100+XHS100 UM_20141027 - P1~50.pdf
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
48
Reset
This function resets Edge Blend to the factory default settings.
Align Pattern
Set to ON to Enable this function to use a test pattern to align and adjust multiple images,
the alignment line is moved according to Blend Width setting.
OSD Introduction – CONTROL
Eco Network Power
Press◄► to set Standard or Eco network power.
Auto Power Off
The default value is OFF. If you set it ON, the projector will automatically shut down after
20 minutes without input signal.
Auto Power On
The default value is Off. If you set it to ON, the projector will automatically start up when it
is connected to the AC power.
Projector Control
Use ◄► to select RS232 or Network for the projector control.
Network
Use this function to display the network conguration.
Start Up Logo
Use◄► select on or off of the start up logo.