Owner`s manual

47
Reset
Reset all the blanking functions to the default settings.
Edge Blend
Edge blend function allows multiple projector images to be seamlessly overlapped. To use
this function, Edge Blend must be enabled on both projectors.
Blend Width
Press Enter to display Blend Width window, use◄► to adjust white level for, bottom, left
and right blending zone. If the Alignment Pattern is enabled, the green alignment line is
moved according the setting value you made. Below is an example of setting blend width.
Top Bottom Left
Right
Note:
Notice the green lines appear to indicate the edge of the screen and the start/end of the blend zone.
Black Level Uplift
Black Level Uplift is used to compensate for the lack of pure black output from projectors,
due to light leaking to the projection screen. When projecting black, the overlapping area
where the two images overlap project twice the projectors’ black output levels. The solution
is to adjust the Black Level Uplift.
Input signal is black, then increase the Black Level Uplift (Top, Bottom, Left, Right) until the
non-overlap area’s brightness matches the overlap area.
Adjust the black level by setting the Selected Area (Top, Bottom, Left, Right) to match
the black levels. You can adjust all colors at the same time or adjust Red, Green or Blue
respectively.
Note:
Four corners, black level uplift adjustment function is not available.
Corner blending, black level uplift adjustment function is not available.
Black balance
Up
Down
Left
Right
All
Red
Green
Blue
Red
Adjustment
Select
0
0
0
0
0
0
0
0
0