Owner`s manual
Table Of Contents
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
- EIKI EIP-UHS100+XHS100 UM_20141027 - P1~50.pdf
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
28
Connecting the AC Power Cord
This projector uses nominal input voltages of 100-240 VAC. It is designed to work with
single-phase power systems having a grounded neutral conductor.
To reduce the risk of electrical shock, do not plug into any other type of power system. If
you are not sure of the type of power being supplied, consult your authorized dealer or
service center. Connect the projector with all peripheral equipment before turning on the
projector.
Note
Unplug the AC power cord or turn off the MAIN ON/OFF Switch when the projector is not in use. When the
projector is in stand-by mode, it consumes a little electric power.