Owner`s manual

17
Notes on Remote Control Operation
 Inmostsituations,youcansimplypointtheremotecontrolatthescreenwhichwillreecttheIRsignal
fromtheremotebacktowardtheIRreceiverontheprojector.Insomecases,however,ambientlightmay
prevent this. If so, try again.
If the effective range of the remote control decreases, or it stops working, replace the batteries with new
ones.
The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or
uorescentlighting.
Remote Control Battery Installation
1. Slide the battery cover to remove it.
2. Install two AA(2) batteries with the correct polarity.
3. Put back the cover.
Notes on Batteries
Make sure that the battery polarities are correct when installing the batteries.
Do not mix an old battery with a new one or different types of batteries.
Avoid contact with water or liquid.
Do not expose the remote control to moisture or heat.
Do not drop the remote control.
If you will not use the remote control for periods long time, remove the batteries to avoid damage from battery
leakage. Please wipe the remote control clean and install new batteries if the battery is leaked.
Dispose of used batteries according to the instructions or your local disposal rule or guideline.
Remote Control Receivers and Operation Range
Infrared Remote Receivers are provided on the front and rear cover. Point the remote
control toward the projector, than press the buttons. Maximum operating range for the
remote control is about 10 meters and ±30 degrees.
SHUTTER
TEMP.
L
AMP 2
L
AMP 1
POWER
STATUS
10m
±30°
10m
±30°
Note:
Whenhangingtheprojectorfromtheceiling,pointtowardtheInfraredRemoteReceiverwhichislocated
fartherawayfromtheuorescentlight.