Owner`s manual
Table Of Contents
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
- EIKI EIP-UHS100+XHS100 UM_20141027 - P1~50.pdf
- Feature and Design
- Overview
- Projector contents
- Terminals and Connectors
- Control Keys and Indicators
- Installation
- Lens replacement
- Positioning Projector
- Lens Shift Adjustment
- Connecting to Computer
- Connecting to Video Equipment
- Trigger connection
- RS-232 Connection
- LAN Connection
- Connecting to wired remote controller
- Connecting the AC Power Cord
- Basic Operation
13
Terminals and Connectors
IN OUT
TEJ
HV
RGBLAN
RS-232
HDMI
DVI-D B/Pb G/Y R/Pr
WIRED REMOTE
TRIGGER
SDI
Input SDI signals to IN and outputs the SDI signals from OUT.
HDMI
Connect the HDMI signal from the video device to this terminal.
DVI-D
Connect the DVI-D output on the computer to the terminal, the terminal can support to
HDCP compatible signal.
5 BNC INPUT JACKS
Connect the RGB signals or YPbPr singals.
WIRED REMOTE
Connect the wired remote control to this jack with a remote control cable (supplied).
TRIGGER
The TRIGGER terminal provides 12V (+/-1.5) output for screen control.
LAN
Connect the Ethernet cable to the terminals for controlling the projector. (page 62)
RGB
Connect a computer output (Analog D-sub 15-pin type) to this terminal.
RS-232
Connect a RS-232(Not supplied) from the computer to the terminal for controlling the
projector.