Owner's Manual
Table Of Contents
- Introduction
- Quick Start
- Setup
- Connections
- Basic Operation
- Useful Features
- Operating with the Remote Control
- Menu Items
- Using the Menu Screen
- Picture Adjustment (“Picture” Menu)
- Adjusting the Projected Image (“SCR - ADJ” Menu)
- Adjusting the Projector Function (“PRJ - ADJ” Menu)
- Auto Sync (Auto Sync Adjustment)
- Auto Power Off Function
- Auto Restart Function
- STANDBY Mode
- Setting the Confirmation Sound (System Sound)
- Audio Output Type Setting
- Speaker Setting
- Audio Input
- Selecting the Transmission Speed (RS-232C)
- Fan Mode Setting
- System Lock Function
- Checking the Lamp Life Status
- Keylock Function
- Setting up the Projector Network Environment (“Network” menu)
- Troubleshooting with the “Help” Menu
- Appendix
40
Picture Adjustment (“Picture” Menu)
Menu operation n Page 38
Q PAGE1 Q PAGE2
Picture Mode
Contrast 0
0
0
0
Bright
Color
Tint
0Sharp
Standard
SEL./ADJ. ENTER END
0
0
Red
Blue
Picture SCR PRJ Net. Help
1
2
Picture Mode
CLR Temp
BrilliantColor
TM
C.M.S. Setting
C.M.S.
Standard
SEL./ADJ. ENTER END
Progressive
Eco+Quiet
0
1
On
3D Progressive
On
DNR
Off
Reset
Picture SCR PRJ Net. Help
7
6
5
4
2
3
1
Selecting the Picture Mode
Selectable
items
Description
The default settings of each item when selecting Picture Mode
CLR Temp BrilliantColor
TM
Eco+Quiet
Standard For standard image 0 1 Off
Presentation Brightens portions of image for
more enhanced presentations.
02Off
Movie Gives natural tint to the
projected image.
–1 0 On
Game Gives sharpness to the
projected image.
01Off
*sRGB For high fi delity reproduction of
images from a computer.
––Off
“sRGB” is displayed only when RGB signal is input.
You can set or adjust each item in the “Picture” menu to your preference. Any changes you make are
retained in memory.
You can also press PICTURE MODE on the remote control to select the picture mode. (See page 33.)
*sRGB is an international standard of color reproduction regulated by the IEC (International
Electrotechnical Commission). As the fi xed color area has been decided by the IEC, the images are
displayed in a natural tint based on an original image, when “sRGB” is selected.
You cannot set the items, “Red”, “Blue”, “CLR Temp”, “BrilliantColor
TM
”, when “sRGB” is selected.
•
•
Note
Info
When “sRGB” is selected, the projected image may become dark, but this does not indicate a
malfunction.
•
•
•