Owner's Manual
Table Of Contents
- Introduction
- Quick Start
- Setup
- Connections
- Basic Operation
- Useful Features
- Operating with the Remote Control
- Menu Items
- Using the Menu Screen
- Picture Adjustment (“Picture” Menu)
- Adjusting the Projected Image (“SCR - ADJ” Menu)
- Adjusting the Projector Function (“PRJ - ADJ” Menu)
- Auto Sync (Auto Sync Adjustment)
- Auto Power Off Function
- Auto Restart Function
- STANDBY Mode
- Setting the Confirmation Sound (System Sound)
- Audio Output Type Setting
- Speaker Setting
- Audio Input
- Selecting the Transmission Speed (RS-232C)
- Fan Mode Setting
- System Lock Function
- Checking the Lamp Life Status
- Keylock Function
- Setting up the Projector Network Environment (“Network” menu)
- Troubleshooting with the “Help” Menu
- Appendix
17
1 Adjusting the focus.
2
Adjusting the height.
3 Adjusting the picture size.
4. Adjust the projected image
_P. 27
Correcting trapezoidal distortion using Keystone Correction.
On the projector
On the remote control
Shrinks
upper side.
Shrinks
lower side.
5. Correct trapezoidal distortion
_P. 2 8
Select the “COMPUTER” using INPUT on the projector or COMPUTER on the remote
control.
On the
projector
On the remote
control
INPUT list
INPUT
COMPUTER
DVI-D Computer
D
DVI-D Video
D
On-screen display (RGB)
RGB
1024 × 768
COMPUTER
When you press INPUT on the projector, the INPUT list appears.
Press '/" to switch the INPUT mode.
•
6. Select the INPUT mode
_P. 2 9
7. Turn the computer on
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
standby mode.
On-screen display
On the
projector
On the remote
control
8. Turn the power off
_P. 2 6