Owner`s manual

33

Ecology
When set to “Yes”, The monitor activates the
following power saving mode.
• “OPC” set to “On” (Page 31)
• “Standby Mode” set to “Mode2” (Page 36)
• “No Operation Off” set to “3 Hours” (Page 32)
• “Power Management” set to “Mode1” (Page 32)
• When selecting “Yes” for “Ecology”, the settings related to
“Ecology” (“OPC”, “Standby Mode”, “No Operation Off”,
and “Power Management”) will be lost. Once you have
selected “Yes” for “Ecology”, these settings will not return
to the previous setting by selecting “No”. To restore these
settings, each setting must be changed individually.
Note
Setup menu
Setup Option
Set Inputs
Input Label
Position
Password
Keylock
Fine Sync
DHCP Client
RS-232C
TCP/IP
Status
All Reset
Auto Restart
Standby Mode

Setting a password
(Password)
If you do not want others to change the setting
for the “Setup” menu, set a password.
1
Select “Password”, then press ENTER.
• The screen for entering the password appears.
Enter your new password.
Use 4 digits.
Old Password
----
----
---
MENU [Setup---Password]
New Password
Reconfirm
2
Press
Ÿ
/
ź
to set the fi rst digit in “New
Password”, then press
Ź
.
3
Enter the remaining 3 digits, then press ENTER.
• To return to the previous digit, press
Ż.
4
Enter the same password in “Reconfi rm”, then
press ENTER.
• The status for “Password” changes to
“
(enable)”.
• Once the password is set, you must enter the password
to change the “Setup” menu settings.
Note
Menu operations