Owner`s manual

15
Connecting Peripheral Equipment
Caution
• Be sure to turn off the power and disconnect the plug from the power outlet before connecting/
disconnecting cables. Also, read the manual of the equipment to be connected.
• Be careful not to mix up the input terminal with the output terminal when connecting cables. Mixing up the
input and output terminals may cause malfunctions and other problems.
• After making all connections, turn on the monitor and then the other pieces of equipment. When
connecting a computer, ensure that it is the last equipment to be turned on after all the connections are
made.
• You may need other cables or connectors not listed below.
S-VIDEO IN
VIDEO IN
AUDIO
COMPUTER IN 1 COMPUTER IN 2 MONITOR OUT
HDMI
DVI IN
Equipment
Terminal on connected
equipment
Cable (commercially available)
Terminal on the
monitor
Computer
RGB output
terminal
RGB cable COMPUTER IN 1
RGB output
terminal
5 BNC to 15-pin D-sub cable COMPUTER IN 2
DVI digital output
terminal
DVI Digital cable DVI IN
DVI-D
(HDCP)
• Images may not be displayed properly depending on the computer (graphics board) to be connected.
• See page
46
“Computer compatibility chart” for a list of computer signals compatible with the monitor.
Use with computer signals other than those listed may cause some of the functions to not work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Macintosh Dealer.
• Depending on the computer you are using, an image may not be displayed unless the computer’s external output port is
switched on. Refer to the specifi c instructions in the owner’s manual of your computer to enable your computer’s external
output port.
Note