Specifications

HOW TO PLAY A RECORDED CASSETTE TAPE
1. Set Function Selector to Tape mode.
2. Push down Stop/Eject button to open Cassette Compartment.
3. Insert a recordedcassette tape intoslides of the open door ofthe Cassette
Compartment. Close the compartment door.
4. Push Play button to start playing.
If you are usinga remote control microphone, be sure that the on/oft switch
is turned to "on".
5. Adjust Volume Control.
6. Adjust Balance Control.
7. Adjust Tone Control knob to your preference.
8. To stop the tape push Stop/Eject button. To eject the cassette, push Stop/
Eject button again.
NOTE: When the end of the tape is reached during playback, the Cassette
Recorder will automatically stop.
If you wish to fast-forward the tape, push Cue button.
To rewind the tape, push Review button.
When the endofthetape isreachedduringfast forward or rewindoperation,the
buttonwill automaticallybe released. Butwhenthe Pausebutton is pushed,the
Cue button or Review button will not be released automatically. In this case,
immediately push the Stop/Eject button.
Using tape counter
The counter provides a means of numerically indexing selections on tape
cassettesand allowsfast returnto specificpartsof the tape. To resetcounterto
"000" at the start of tape, press reset button. The counter conforms to 2X ANSI
standards.
TheTape Counterishelpfulwhen recordingandre-recordingatapeinsegments.
Using review and cue buttons
For a quick review, back up the tape by pressing Review button (leaving Play
button down) and hold it for the desiredtime. When Review button is released,
unit returnsto play mode.
To advancetapeto anothersection,pressCuebutton(leavingPlaybuttondown)
and hold it for desired time. When Cue button is released, unit returnsto play
mode.
I
Using pause button
The Pause button is used to instantly stop the tape transport without releasing
the Play button. Push this button once to stop tape movement; push it again to
restart tape.
The Pause button also is useful in recording since it instantly stops the tape.
8