Specifications

I
BEFORE YOU START TO ENJOY YOUR NEW STEREO PLAYER/RECORDER
ABOUT CASSETTE TAPES
You can use any standard cassette tapes with your unit.
Every cassette tape has two tabs which you can remove to prevent erasure of
recordings. If you wish to record on a cassette with the tabs removed, place a
piece of tape over the tab holes.
NOTE: If the tabs are removedfrom the cassette, or there is nocassette in the
unit, the Record Button cannot be pushed down.
Insert the cassette into the tape compartment with the tape facing up. During
recordingand play,thetape movesfrom the leftto the rightrollerofthe cassette.
When all of the tape has been wound on the right roller, the unit stops
automatically. Remove the cassette, turn it around and re-insert it to record or
to play.
TAB
FORSIDE2
BREAK WITH SCREWDRIVER
(NOT MAGNETIC)
I
Operating on AC current
This unit may be operated on regular 120-volt 60 Hz AC current. 5.6 feet (1.7
meter) AC cordfits snugly within open storage compartment on bottom of unit.
Plug cord into a properly grounded wall outlet. The three-prong plugshould be
usedwithout a two-prong adapter whenever possible. If an adapter is used, be
certain the green wire or grounding tab on the adapter is attached to the screw
on the wall outlet plate for proper grounding.
CAUTION: If it is necessary to use a power cord adapter, have a trained
electrician install the adapter to the outlet and check wiring to be sure there is
noshock hazard. Faultywiring cancausedamage tothe unitandpossible injury
to the operator.
WARNING: Unplug the unit from power supply when not in use.
6
-- .-