392 Overhead Projector
IMPORTANT SAFEGUARDS When using your EIKI 392 overhead projector, basic safety precautions should always be followed, including the following: 1. Read the following instructions carefully before operating the EIKI overhead projector. 2. Make sure that the operating voltage of the overhead projector corresponds to your local voltage. 3. Care must be taken to ensure the smooth airflow of the cooling system. Immediately switch off the machine if the fan is not functioning properly. 4.
TABLE OF CONTENTS Page Name of Parts 3 Specifications and Technical Data 4 Operation Procedure 5 Maintenance & Repair 6 2
NAME OF PARTS Head Mirror Focus Knob Safety Interlock (at the edge of the cabinet) Stage Glass Post Fresnel Lens Lock Lever Stage Lock Lamp Change Knob Power Switch 3
SPECIFICATIONS AND TECHNICAL DATA Lamp EYB 360 watt Voltage 120V/60Hz Lamp changer Provides space and ability to switch between lamps. Single Lamp Provided Safety switch Automatic Power Shut Off Working stage 10” X 10” Projection angle 360°rotation and tilting angle up to 60° Focal length Single Element lens f=285mm Light output 2200 Lumens Packing dimensions 20.7”X18.7”X13.3” Gross Weight 21.12 lbs.
OPERATION PROCEDURE 1. Be sure the voltage of AC outlet corresponds to the projector before connecting the AC power cord. 2. Pull up the post to set up the Head Mirror to an up-right position until the post is locked automatically. (See fig.1) fig. 1 fig. 2 3. Tilt up the projection mirror. 4. Turn the switch on the projector. 5. Adjust the projection mirror horizontally and vertically to center the light on the screen. 6.
MAINTENANCE AND REPAIR 1. Replacing the lamp a) Disconnect the power before replacing the lamp. b) Wait until the lamp is cooled down. c) Pull the stage lock to open the projection stage. d) Push the lever to open the condenser lens frame. (See fig.3) e) Remove the defective lamp and replaced it with a new lamp. Adjust the filament to the center of the reflector. (See fig.4) f) Place the condenser lens frame to original position and close the projection stage. fig. 3 fig. 4 2.
Limited 3 Year Warranty Eiki International warrants this product when sold to the original purchaser from an authorized Eiki dealer, to be free from defective materials and workmanship for a period of 3 years. (Lamp and fuses excluded) Eiki agrees to repair any defect or furnish a new or equal part through an authorized Eiki Service Dealer or Service Center without charge within this period.
