Data Sheet

ND1070
Neo High Frequency Driver
Key Features
109 dB SPL 1W / 1m average sensitivity
1 inch exit throat
44 mm (1 3/4 inch) edgewound aluminum voice coil
100 Watt program power handling
Titanium dome over polyester suspension
Proprietary phase plug design
Neodymium magnetic structure
Excellent thermal exchange
General Description
The ND1070 1-inch exit high frequency compression driver has been
designed for use in high quality two-way audio systems.
Equipped with Proprietary Phase Plug architecture, ND1070 shows
high level manufacturing consistency and a smooth coherent
wavefront at the horn entrance across the whole working frequency
range. With its short openings and high flare rate value, this phase
plug configuration assures low distortion and demonstrates
remarkable improvements in mid-high frequency reproduction.
The ND1070 diaphragm assembly is composed of a titanium dome
sandwiched to a proprietary treated polyester suspension. This
design maintains low resonance and lowers the minimum crossover
point value to 1.6 kHz.
An edge-wound aluminum voice coil wound on proprietary treated
Nomex completes the diaphragm assembly. Nomex shows a 30%
higher value of tensile elongation at a working operative
temperature (200°C) when compared to Kapton. This feature
enables proper energy transfer control from the voice coil to the
dome in real working conditions. Moreover, this proprietary former
material is also suitable for use in high moisture content
environments.
A copper ring on the pole piece reduces inductance above 10 kHz,
improving phase and impedance linearization.
By careful use of elementary pieces of neodymium magnets,
Eighteen Sound engineers have developed a powerful neodymium
magnet assembly capable of reaching 18KGauss in the gap within a
compact and lightweight structure.
The custom designed O-ring creates a tight seal between the plate
and the cover assuring air chamber loading.
Excellent heat dissipation and thermal exchange are guaranteed by
the direct contact between the magnetic structure and the
aluminum cover which leads to a lower power compression value.
The ability to perform properly under inclement weather conditions is
a key feature in Eighteen Sound philosophy. A special treatment has
been applied to the magnet and the top and back plates of the
magnetic structure making the driver more resistant to the corrosive
effects of salts and oxidization. This treatment is more effective
than any other treatment used by other manufacturers.
0421T8M400 8 Ohm
0421T6M400 16 Ohm
NEODYMIUM HF DRIVERS
[e-mail]
www.eighteensound.com