Technical data

4 16 Reserved

5 32 Reserved

6 64 Reserved

7 128 Reserved

ATS91=<bitmask> Bit Value Result

0 1 Use reverse SDLC establishment (SNRM sent by answerer and not by

caller). Mandatory for POS.

1 2 Poll on each SDLC frame. Required by some POS terminals.

ATS92=<n> SDLC Address A (default 0x30)

ATS128 S-register 128 is a read-only register. Reading this register allows to retrieve information

on the current (last) incoming call. It returns a message in the following format:

;<calling party number>;<destination_address>. If calling party or destination sub-

addresses are present, they are separated by a slash "/" from the called party number or

the destination address. For example, the calling party number 800, calling party sub-

address 900, destination address 400, destination sub-address 500 are presented as:

;800/900;400/500.

ATS172=<bitmask> Bit Value Result

0 1 Enable transmission and reception of empty frames.

1 2 Enable "multimoding", i.e. a trailing byte (modulation tag) in every

frame specifies which modulation has to be used to send this frame or at

which modulation it was received. Valid modulation tags are 0x27 for

V.23 HDX off hook and 0x28 for V.23 HDX on hook.

2 4 Shield empty frames. This mode enables a tty application to send and

receive empty frames. Since a frame with a length of 1 byte is invalid in

the V.23 SMS and V.23 Caller ID protocol, it is used to carry the

information that an empty frame occurred and which modulation was

detected. The data byte in a real 1 byte frame is replaced by a unique

value 0xff. A single byte frame 0x27 indicates or issues an empty frame

in V.23 HDX off hook. A single byte frame 0x28 indicates or issues an

empty frame in V.23 HDX on hook.

ATS253=<n> <n> (0 ...

127)

Description

Set Write allows to set coded in accordance with Q.931 cause value to be

used to disconnect this call (for example by ATH/ATZ commands or by

DTR drop operation). The Dialogic

Diva

Media Board provides

conversion between used national dependent values/in band procedures

and Q.931.

Read Read after disconnect provides coded in accordance with Q.931 value of

disconnect cause. The Dialogic

Diva

Media Board provides conversion

between used national dependent values/in band procedures and Q.931.