Technical data

- Extended modulations V.23 half duplex, V.23 on hook (SMSC mode), V.23 off hook, Bell 202 (POS),

Telenot

The following requirements have to be met for the installation of the Dialogic

Diva

System Release software:

• A PC-compatible computer (pentium processor or higher with at least 500 MHz and 128 MB RAM). Verify

specific requirements for your Dialogic

Diva

Media Board at the Dialogic web site www.dialogic.com

http://www.dialogic.com.

• An installed Linux system

• At least 80 MB of free space on the drive on which your Linux system is installed

• An installed Diva Media Board or valid licenses for the Dialogic

Diva

softIP software

Note: If you upgrade from the Dialogic

Diva

System Release software v8.3, the existing configuration cannot

be used due to structural changes. A backup of the configuration is stored under divas_cfg.rc.8.3.

The following steps provide an overview of the installation and configuration procedure for the Dialogic

Diva

System Release software:

1. Install your Dialogic

Diva

Media Board and connect it to the network. For further information on the

hardware installation, refer to the Dialogic

Diva

Media Board Installation Guide that came with your Diva

Media Board.

2. Install the Diva System Release software package. For further information, see Software installation on

page 16.

3. Configure the Diva System Release software using the Config Configuration Wizard located in the

/usr/lib/opendiva/divas directory. For further information, see Configuring the Dialogic® Diva® System

Release Software on page 22.

4. Confirm the operation of your Diva Media Board. For further information, see Testing the Dialogic®

Diva® Media Board functionality and connectivity on page 33.

5. Configure the Diva System Release software TTY devices. For further information, see Configuring the

Dialogic® Diva® TTY ports on page 35.

System requirements

Installation and Configuration