Specifications

Installing the Eiconcard S5x 7
c)
If there is a metal plate at the end of the slot, remove it and keep
the screw.
d)
Firmly insert the adapter into the selected slot.
To avoid damaging your hardware, insert the adapter
only into a slot with the same bus type as the adapter.
Inserting the adapter into any other type of slot can
damage your adapter, your PC, or both.
Figure 2. Inserting the Eiconcard S5x.
e)
Fasten the adapter with the screw (to ensure that the adapter
is properly secured and grounded to the PCs chassis).
f)
Replace the cover of your PC as described in your PCs
manual.
g)
Reconnect the power cable.
Note
Although the Eiconcard S5x can be installed in any available
ISA expansion slot (unless the PC’s documentation specifies
otherwise), it is recommended that you install the card in a 16-bit
slot to take advantage of the higher IRQs and memory-address
locations available only through 16-bit slots.
4 Set the interrupt request level and memory segment address
These parameters are set using the Eicon Networks networking
software that you purchased with the Eiconcard S5x. Consult the
documentation included with the networking software for
instructions on how to configure the Eiconcard.
To determine the correct interrupt request level and memory
segment address values to use, follow the instructions in Software
Configuration on page 25, then continue with Step 5.
screw
ISA slot
ISA
Eiconcard