Specifications

6 Installing the Eiconcard S5x
Installing the Eiconcard S5x
Follow the steps below to install the Eiconcard S5x. If you want the
Eiconcard S5x to be available to multiple users on a LAN, install it
in the PC that will function as a gateway for the LAN.
1 Prepare the PC
Turn off the PC and disconnect its power cable. Remove the cover
of the PC according to the instructions that came with it.
2 Prepare the Eiconcard
Prepare the Eiconcard S5x by selecting its I/O address and
communications interface.
a)
Set the I/O address. The default I/O address is 380h. You only
need to change this setting if another card already installed in
the PC uses an I/O address in the range 380h to 387h. To
change the I/O address, follow the instructions in Setting the
I/O Address on page 22, then continue with Step 1(b) below.
b)
Select the interface. The default setting enables the V.24 and
V.35 interfaces; to use these interfaces, continue with Step 2
below. To enable the X.21 interface instead, follow the
instructions in Selecting an Interface on page 24, then
continue with Step 3.
3 Install the Eiconcard S5x
a)
Drain static electricity from your body by touching the metal
chassis (the unpainted metal at the back of your PC).
b)
Locate a slot in your PC that has the same bus type as your
adapter.
If your PC has both ISA and PCI slots, the ISA slots are longer,
as shown.
Figure 1. Locating a PCI slot
PCI slots
metal plates
ISA slots