User manual

Web Interface Settings Glossary 121
DSR loss delay
Defines how long Data Set Ready (DSR) must be lost to determine that there has
been a valid loss of carrier, not just a temporary fluctuation. A valid loss of DSR usually
means the modem will hang up.
Range: 0-10000 milliseconds. Default: 1500.
Max delay between rings
Defines the permitted delay between rings. If this timer is exceeded, it is assumed that
the caller has hung up.
Range: 1-9000 milliseconds. Default: 5000.
Min DSR (on) state delay before going off hook
Defines the delay before going into data transfer mode.
Range: 0-4000 milliseconds. Default: 2000.
Send a command message delay
Defines the delay between sending a command message to the V.25bis modem and
its acceptance. If this timer is exceeded then the command message is returned with
an error code.
Range: 200-4000 milliseconds. Default: 200.