Network Device Reference Guide

Manufacturer Command

The purpose of the parameter manufacturer command is to specify the kind of operation requested

in a MANUFACTURER_REQ.

The following manufacturer commands are defined:

1: Assign PLCI

2: Advanced Codec control

3: DSP control

4: Signaling control

5: RXT control

6: IDI control

7: Configuration control

8: Remove Codec

9: Options request

This information element appears in:

Manufacturer Specific

Manufacturer Command Parameters

The purpose of the parameter manufacturer command parameters is to specify command

dependent parameters.

Parameters for manufacturer command 9: Options Request:

dword Options mask Manufacturer specific options that have to be enabled:

[Bit 0..5]: reserved, must be set to 0

[Bit 6]: Enable FAX paper formats and resolutions

[Bit 7..31]: reserved, must be set to 0

This information element appears in:

Manufacturer Command