User manual

DIVA T/A ISDN Modem Reference Guide
◆
Page 59
Analog Device Commands
The following table describes the analog device commands. These commands are only
available on units with the optional analog device ports.
AT*An= v
Abbreviated Ring Control
(North America only). Specifies whether Visual Message
Waiting's abbreviated ring is enabled or disabled.
n=1 Analog device port 1 (PHONE 1).
n=2 Analog device port 2 (PHONE 2).
v= 0 Disabled.
v=1 Enabled (default).
AT*Bn=v
ISDN Bearer Capability
. Specifies the bearer capability for ISDN calls on the analog
device interface.
n=1 Analog device port 1 (PHONE 1).
n=2 Analog device port 2 (PHONE 2).
v=0 Outgoing analog device calls use Speech encoding (default).
v=1 Outgoing analog device calls use Audio 3.1Khz encoding. This setting is
recommended for modem/fax calls.
Note: This parameter does not take effect until you restart your DIV AT/A.
AT*Cn
Analog Device Caller ID Delivery
. Specifies whether analog device caller ID delivery
is enabled or disabled (North America only). When enabled telephones with Call Display
will display incoming call information.
n=0 Disable analog device caller ID delivery.
n=1 Enable analog device caller ID delivery (default).
Note: This parameter does not take effect until you restart your DIV AT/A.
AT*Dn=v
Internal Dial Access
. Controls the internal dial access for supplementary services.
n=1 Analog device port 1 (PHONE 1).
n=2 Analog device port 2 (PHONE 2).
v=0 Disable internal dial access. This setting is recommended for modem/fax calls.
v=1 Enable internal dial access (default).
Note: This parameter does not take effect until you restart your DIV AT/A.
AT*En=v
Enable/disable Incoming and Outgoing Calls
. Specifies the type of calls (outgoing
and incoming) permitted on an Analog Port. Each Analog port can be set
independently.
n=1 Analog device port 1 (PHONE 1).
n=2 Analog device port 2 (PHONE 2).
v=0 Disable port.
v=1 Outgoing calls only.
v=2 Incoming calls only.
v=3 Incoming and outgoing calls (default).