Technical data

53
ATS254=<bitma
sk>
Bit Value Result
0 1 Allows to reject incoming call using ATH, ATZ commands or using
DTR drop procedure.
1 2 Activate TIES (Time Independent Escape Sequence). The TIES
procedure switches to command mode if "+++AT<CR>" (where
<CR> represents hex digit 0x0D) sequence is detected in the
data stream after a 20 ms pause and is followed by a 40 ms
pause.
ATS1001=<num
ber>
Second origination address. This number is placed as the second origination address.
ATS1002=<num
ber>
Specifies the numbering plan identifier for the second origination address. Number
should be in the range 0...255. If number is set to 128 or larger then octet 3a
(presentation and screening indicator) is not used.
ATS1003=<num
ber>
Specifies the presentation (bits [7:6] in octet 3a of origination address) and screening
(bits [2:1] in octet 3a of origination address) for the second origination address.
Number should be in the range 0...127.
AT\ commands
AT
command
Description
AT \V[<n>] <n> CONNECT message format
0 Plain CONNECT message without any connection parameters.
1 Full CONNECT message including connection parameters (modulation, compression,
transmit/receive rate).
2 Full CONNECT message in multi-line format: CONNECT, TX/RX, CARRIER, PROTOCOL,
COMPRESSION.
AT
\T[0...65535
]
Inactivity timeout (s). TTY releases the connection if there was no data traffic on the interface for the time
interval specified here.
AT \D[<n>] Debug level. Reserved for use by Dialogic Corporation.
AT \N[<n>] <n> Error correction control
0|1 Turn off error correction, error correction detection, and data compression (i.e. connect in
transparent mode only).
2 Disable V.42 error correction and V.42 error correction detection (i.e. MNP only). In case of