Technical data

129
Under Use DID Length, you can either select the length of the DID number or the use of a special number. The
latter lets you configure a number with less digits, in many companies needed for the receptionist. If you select
this option, you need to enter the number in Use Special Number.
Advanced configuration method
The Advanced configuration method allows for routing calls to a certain application, e.g., to a fax application. If
you select this method, you can configure the call routing for each controller. Note that if the first rule for a
called party number matches, the remaining rules for the same number are ignored.
1. Use the wildcard character "*" if any Called Party Number should be matched. You can also enter a single
number or a range of numbers.
2. Select the controller to be used for the call routing. If you activated the option Direct Inward Dialing in
Board configuration, you can select Any and thus create a common call routing for all installed
controllers.
3. Under Call Distribution, select how the call should be handled. If you select Broadcast, the call is routed
to the running applications on all interfaces. If you select Forward to, you need to enter the number to
which the call should be routed and you need to select an interface.
4. For more information, see the online help for each parameter.