Specifications

AT Commands and Result Codes

◆

◆◆

◆

AT \V<n> Connect message format control - Only single-line connect messages are

supported.

n=0: Connect messages are controlled by the command settings X, W, and S95.

n=1: Connect messages will be in a single-line format, as described below, but still

subject to the B and Q commands.

Format: CONNECT<DTE SPEED></Modulation></Protocol></Compression>

</Line Speed>

n=0

AT +MS Selects the modulation and, optionally, enables or disables automode, specifies

the lowest and highest connection rates, selects m-Law or A-Law codec type, and

enables or disables robbed bit signaling generation (server modem) or detection

(client modem). The command format is:

+MS= <mod> [,[<automode>][,[<min_rate>][,[<max_rate>][,[<x_law>]

[,[< rb_signaling>]]]]]]<CR>

—

Command Function Default