Specifications

Installing Diva Mobile for Windows NT
◆
◆◆
◆
34
7. In the ‘Configure Port Usage’ dialog box, select ‘Dial out only’, then click ‘OK’.
8. In the ‘Remote Access Setup’ dialog box, click ‘Clone’ to add a second port with the
same configuration as the first port.
9. In the ‘Remote Access Setup’ dialog box, click ‘Add’.
10. In the ‘Add RAS Device’ dialog box, select ‘COMx-Eicon Diva Mobile V.90 Modem’
(where x depends on your system).
11. Click ‘OK’. This adds an analogue modem port.
12. In the ‘Remote Access Setup’ dialog box, select ‘COMx-Eicon Diva Mobile V.90
Modem’, then click ‘Configure’.
13. In the ‘Configure Port Usage’ dialog box, select ‘Dial out only’, then click ‘OK’.
14. In the ‘Remote Access Setup’ dialog box, click ‘Network’.
15. In the ‘Network Configuration’ dialog box, select the dial-out protocols you need to
use. To connect to the Internet, select only ‘TCP/IP’. Deselect all other protocols.
16. Click ‘OK’. The ‘Remote Access Setup’ dialog box appears. It should look similar to
the one shown below:
17. Click ‘Continue’. The setup program copies files to your notebook.
Note: CAPI 2.0 is automatically installed. CAPI allows you to use applications that are
based on the Common ISDN application programming interface.
Complete the installation
1. In the displayed message box, click ‘OK’ to launch the ‘Network Control Panel’.
2. In the ‘Network Control Panel’, click ‘OK’.
3. When prompted, restart your notebook to complete the installation.