Specifications

Installing Diva Mobile for Windows NT
◆
◆◆
◆
27
To install and configure protocols specified by your ISP or network administrator
(A) Install the protocols
1. Open the ‘Network’ dialog box: click ‘Start > Settings > Control Panel’. Double-click
the ‘Network’ icon.
2. In the ‘Network’ dialog box, click the ‘Protocols’ tab.
3. If all the required protocols appear in the ‘Network Protocols’ list, then they are
installed. Continue with ‘Configure the protocols’ below.
4. If a required protocol does not appear in the ‘Network Protocols’ list, install it. To install
a protocol:
• In the ‘Network’ dialog box, click ‘Add’.
• In the ‘Select Network Protocol’ dialog box, select the required protocol, then click
‘OK’.
• Follow the on-screen instructions. If prompted, reboot your notebook.
(B) Configure the protocols
You must configure each protocol with the values specified by your ISP or by your network
administrator.
1. If the ‘Network’ dialog box is not open, open it: click ‘Start > Settings > Control Panel’.
Double-click ‘Network’.
2. In the ‘Network’ dialog box, click the ‘Protocols’ tab.
3. From the ‘Network Protocols’ list, double-click a protocol you need to configure.
For example, if you plan to connect to the Internet or to a TCP/IP network, double-click
this item:
4. In the displayed dialog box, use the various tabs to enter the properties specified by
your ISP or by your network administrator (see ‘Internet and Remote Access (ISDN
or analogue)’ in ‘Requirements’ on page 11).
When you are done, click ‘OK’ to close the dialog box.
5. Click ‘OK’ again to close the ‘Network’ dialog box.
6. If you are prompted for your Windows NT CD-ROM or a specific Windows NT diskette:
Insert your Windows NT CD-ROM or the appropriate diskette into a suitable drive. In
the ‘Windows NT Setup’ dialog box, type the path to the CD-ROM or diskette, then
click ‘Continue’.
7. If prompted, reboot your notebook.
8. Repeat this procedure if you need to configure more protocols.