Specifications

Installing Diva Mobile for Windows NT

◆

◆◆

◆

CHAPTER 6

Installing Diva Mobile for Windows NT

This section includes information on the following:

• Configuring Windows NT Networking

• Installing the Diva Mobile V.90 PC Card

• Installing the Diva Mobile for Windows NT software

• Connecting to the Internet under Windows NT

Configuring Windows NT Networking

Before you install Diva Mobile for Windows NT, make sure that Windows NT Networking

and the protocols specified by your Internet Service Provider (ISP) or by your network

administrator are installed on your notebook.

Note: A protocol is a ‘language’ computers can use to communicate. Computers that

need to communicate with each other must use the same protocol.

In general:

• If you will be connecting to a Windows NT RAS server, you need one or more of the

following protocols: NetBEUI, TCP/IP, or IPX. You must use protocols that are

supported by the RAS server.

• If you will be connecting to an ISP or to a TCP/IP router, you need the TCP/IP protocol.

To determine if Windows NT Networking is installed

• Click ‘Start > Settings > Control Panel’. Double-click the ‘Network’ icon.

If the ‘Network’ dialog box appears, then Windows NT Networking is installed. Continue

with To install and configure protocols specified by your ISP or network administrator

If the following message box appears, then you must install Windows NT Networking

before proceeding. Make sure you have your Windows NT CD-ROM or diskettes

available.

For more information, see your Windows NT documentation. During the Windows NT

Networking setup, you are prompted to select an adapter; if you do not have a network

interface card, select the MS Loopback adapter.

Click ‘Yes’ to install

Windows NT Networking.