User`s guide

Appendix C: Command Line Reference ISDN
169
MINIMAL: Reduces NetBIOS traffic to a minimum. Does not support Network Neighborhood functions.
However, does support the MAP NETWORK option in Windows Explorer and DOS-based networking
commands such as net use, net view, and net logon. Most economical solution.
NONE: The DIVA LAN ISDN Modem discards all NetBIOS traffic. NetBIOS services are not supported
across the ISDN link.
ENABLE IP SPOOFING
DISABLE IP SPOOFING
Valid context: General
Enables or disables spoofing. When enabled, the DIVA LAN ISDN Modem does the following:
- spoofs all TCP keep alive datagrams
- spoofs all Microsoft Server Message Block datagrams
- drops all NetBIOS over IP name service traffic
ENABLE IP MULTICAST
DISABLE IP MULTICAST
Valid context: Profile
Enables or disables support for IP multicasting. When disabled (default settings), the DIVA LAN ISDN
Modem does not forward IP multicast datagrams from the WAN onto the LAN. To allow computers on the
Ethernet LAN to subscribe to services that use IP multicasting as a delivery mechanism, you must enable this
option.
ENABLE IP MANUALDIAL
DISABLE IP MANUALDIAL
Valid context: Profile
Enables or disables manual dialing of this profile. When enabled, the DIVA LAN ISDN Modem will not
automatically connect the profile when data needs to be sent. Instead, you must manually connect the profile.
Use the Dial command to do this.
ENABLE IP UNNUMBERED
DISABLE IP UNNUMBERED
Valid context: Profile
Enables or disables IP unnumbered mode for this profile. Permits you to save an IP address by using the same
IP address for the DIVA LAN ISDN Modem on both the Internet and internal LAN. Only valid if NAT is not
enabled.
ISDN
ENABLE ISDN TEISHARING
DISABLE ISDN TEISHARING
Valid context: General
Enables or disables the sharing of TEI assignments. Some switches only make two TEIs available for an ISDN
line. Therefore, if you are using AO/DI, enable this option. This shares the TEI between channels B1 and D.
TEISHARING is disabled by default and is only available if TEI assignment is
dynamic (SET ISDN TEI DYNAMIC).