Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Diagnostics
Page 2-36Conducting Diagnostics
2
Ter mio
The Termio option displays the general terminal interface data associated with
the serial card. It is similar to the “stty” command in that it prints all enabled
termio flags.
To display the termio, do the following:
1. Starting at the Megaport and Megaplex Configuration and Diagnostics
screen (Figure 2-25
), select
2. Press .
The system displays the Prompt window (Figure 2-28
).
3. Enter the name of the device to be verified.
The system displays the Termio window.
Register Dump
The Register Dump option displays a real-time window of the on-board registers.
The data is in raw form and useful to only Equinox technical personnel. It is used
to obtain information about the hardware status and various software flags.
To display the Register Dump, do the following:
1. Starting at the Megaport and Megaplex Configuration and Diagnostics
screen (Figure 2-25
), select
2. Press .
The system displays the Prompt window (Figure 2-28
).
3. Enter the name of the device to be verified.
The system displays the Register Dump window (Figure 2-30
).
> Termio
> Port Stats
ENTER
> Register Dump
> Port Stats
ENTER