Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Diagnostics
Page 2-26Conducting Diagnostics
2
10. Stop the test and remove the channel from the loop-around mode by
completing the following Steps a through c:
a. Select
The system displays the Stop Network Loop-Around Test window
(Figure 2-18
).
Figure 2-18. Stop Network Loop-Around Test Window
b. To stop testing the channel, enter the appropriated channel number
in the
Channel
: field. This is the same channel number entered in
Step 6
above.
The system displays the message
working...
in the upper right
corner of the screen, removes the channel from loop-around mode,
and displays the Test Results window (Figure 2-19
).
Figure 2-19. Stop Test Results Window for a Network
Loop-Around Test
11. Press (Cancel) to exit the screen and return to the Networking
Diagnostics menu (Figure 2-10
).
12. Repeat Steps 2
through 11 for each channel to be tested.
>
Stop Test
> Network Loop-Around Test
F6