Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Troubleshooting
Page 1-20Hard Disk Drive Access Troubleshooting
1
The System Displays Failure to Load MIP, SIP, or
vfs_mount Message
If the system displays one of the following messages see the troubleshooting
procedures in Table 1-19
.
NOTE:
Once the system has tried to access the SCSI devices it will try to access
Hard Disk Drive 0. If the system displays the UNIX logo, Hard Disk Drive 0
has been successfully accessed.
Can not load MIP
Can not load SIP
vfs_mount failed
NOTE:
A system panic may occur at this point.
Table 1-19. The System Displays Failure to Load MIP, SIP, or vfs_mount Message
Possible Cause Check/See Probable Fix
The stand file system is
corrupted.
Check the stand file status. 1. If the system is mirrored,
boot off of the backup
hard disk drive.
2. If the system is not
mirrored, or if the
problem persists,
restore or reload the
system.
Continued on next page