Instruction manual

INTUITY Messaging Solutions Release 4

MAP/5P Maintenance

585-310-186

Issue 3

October 1997

Troubleshooting

Page 1-18Hard Disk Drive Access Troubleshooting

The System Displays SCSI Target 0 LUN 0 Not

Found Message and Stalls

If the system displays the following message and stalls see the troubleshooting

procedures in Table 1-17

SCSI target 0 LUN 0 not found

At this point the system stalls.

NOTE:

If you press the system displays the following

message:

No boot device available

Strike F1 to retry boot, F2 for setup utility

Table 1-17. The System Displays SCSI Target 0 LUN 0 Not Found Message and Stalls

Possible Cause Check/See Probable Fix

Hard Disk Drive 0 is

defective.

Check the status of Hard

Disk Drive 0.

1. Replace Hard Disk

Drive 0.

Continued on next page

CONTROL ALT DELETE