Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Troubleshooting
Page 1-16Hard Disk Drive Access Troubleshooting
1
The System Displays SCSI Target 0 LUN 0 Not
Found Message with Several Additional
Messages
If the system displays the following series of messages see the troubleshooting
procedures in Table 1-16
.
The system displays the following message:
Checking for SCSI target 0 LUN 0
After several minutes the system displays the following
messages:
SCSI target 0 LUN 0 not found
Target-LUN x-0.....
....
Target-LUN y-0....
No boot device available
Strike F1 to retry boot, F2 for setup utility