Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
MAP/5P Platform Alarms
Page E-2Platform Alarms
E
Platform Alarms
Ta b l e E- 1 lists the alarms associated with the MAP/5P as well as possible repair
actions.
Table E-1. Platform Alarms
Alarm Message Repair Action
CMOS Battery Error Replace the battery. See “CMOS Battery
Replacement” in Chapter 7, ‘‘Replacing
Other Components’’.
CMOS Checksum Error 1. Replace the battery. See “CMOS
Battery Replacement” in Chapter 7,
‘‘Replacing Other Components’’.
2. If Step 1 does not work, run setup by
pressing
|
or
b+a+^
Display Card Mismatch Run setup by pressing
|
or
b+a+^
Diskette Drive Controller Error or Not
Installed
Check the diskette cable connections. See
“Diskette Drive Replacement
” in Chapter
7, ‘‘Replacing Other Components’’.
Diskette Drive Error Diskette may be defective. If the diskette is
good, replace the diskette drive. See
“Diskette Drive Replacement
” in Chapter
7, ‘‘Replacing Other Components’’.
Diskette Drive A Type Mismatch Run setup by pressing
|
or
b+a+^
and
select the proper drive type.
Diskette Drive B Type Mismatch Run setup by pressing
|
or
b+a+^
and
select the proper drive type.
Equipment Configuration Error. Check the memory configuration.
Hard disk Controller Error Run setup by pressing
|
or
b+a+^
Hard disk 0 Error Check all cable connections. Replace
Hard Disk Drive 0. See “Recovering from a
Hard Disk Drive 0 Failure” in Chapter 6,
‘‘Replacing the Hard Disk Drive’’.
Hard disk 1 Error Check all cable connections. Replace
Hard Disk Drive 1. See “Recovering from a
Hard Disk Drive 1 Failure” in Chapter 6,
‘‘Replacing the Hard Disk Drive’’.
Keyboard Error or No Keyboard Connected Check and connect the keyboard to the
MAP/5P.
Continued on next page