Instruction manual
INTUITY Messaging Solutions Release 4
MAP/5P Maintenance
585-310-186
Issue 3
October 1997
Troubleshooting
Page 1-14Hard Disk Drive Access Troubleshooting
1
A pin on the Hard Disk
Drive 0 SCSI Bus cable
connector is bent or
broken.
Check the pins on Hard
Disk Drive 0 by doing the
following:
1. Remove the SCSI Bus
cable.
2. Check the pins on the
hard disk drive.
1. If a pin is bent,
straighten the pin.
If a pin is broken,
replace the hard disk
drive.
2. Reboot the system.
A pin on the P5 CPU circuit
card SCSI Bus cable
connector is bent or
broken.
Check the pins on the P5
120 MHz circuit card by
doing the following:
1. Remove the SCSI Bus
cable.
2. Check the pins on the
circuit card.
1. If a pin is bent,
straighten the pin.
If a pin is broken,
replace the circuit card.
2. Reboot the system.
Table 1-15. The System Displays No Boot Device Available Message with Ident-Strings
— Continued
Possible Cause Check/See Probable Fix
Continued on next page