Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Disaster Recovery Checklists
Page D-13Disaster Recovery Checklists
D
Checklist for Field Reloading a Lodging Only
System
Table D-7. Checklist for Field Reloading a Lodging Only Systems
✓ Task Source
Locate the most recent full attended backup
tape. You will also need to use the nightly
backup tape which should be located in the
cartridge tape drive.
!
WARNING:
The attended backup tape contains
subscriber data. If you do not have the
attended backup tape, the system will
loose all subscriber data and messages,
and you will need to re-administer all
subscribers. Contact your remote
support center and inform them of the
condition.
Shutdown the system if the system is
responding to commands.
NOTE:
If the system is not responding to
commands, then continue with the
procedures in this checklist.
“Shutting Down the Lucent
Intuity System” in Chapter
3, ‘‘Common System
Procedures’’
Leave Hard Disk Drive 0 connected to the SCSI
bus.
Verify the CMOS settings. “Verifying the CMOS
Settings” in Chapter 7,
‘‘Replacing Other
Components’’
Verify the SCSI host adapter settings. “SCSI Controller Circuit
Card” in Chapter 5,
‘‘Replacing or Installing
Circuit Cards’’
Low level format the hard disk drive. “Performing a Low-Level
Format” in Chapter 6,
‘‘Replacing the Hard Disk
Drive’’
Continued on next page