Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing an RFU
Page 11-2Installing an RFU
11
Installing an RFU
The Lucent™ INTUITY™ system uses two procedures for loading a RFU:
1. On-site installation
2. Remote download
Remote downloads of an RFU are done by your remote maintenance center. If
the remote maintenance center downloads an RFU, it will not be necessary to
install the RFU on-site. RFUs contain updates to the basic system software.
NOTE:
If Lucent INTUITY system software (operating system and base software) is
being installed, see “Installing UnixWare
” in Chapter 8, ‘‘Installing Base
System Software’’.”
!
CAUTION:
Always verify with the remote maintenance center that the RFU is the most
recent RFU available before loading.
The following procedures are to be used for installing an RFU to an existing
system that requires a new RFU. Do not use these procedures to load an
RFU to an ALT (assembled, loaded, and tested) system which already has
the RFU installed. Contact the remote maintenance center with questions
about RFU identity and procedures.
Removing an Existing RFU
1. Stop the voice system. See “Stopping the Voice System” in Chapter 3,
‘‘Common System Procedures’’,” for the procedure.
2. Start at the Lucent I
NTUITY Main menu (Figure 11-1).
Figure 11-1. Lucent INTUITY Main Menu