Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing the Optional Feature Software
Page 10-4Installing UNIX Multi-User Software
10
8. Select
yes
for the User Upgrade.
9. Press with the cursor on
Apply
.
The system displays the following message:
READY TO PROCESS
Set: Multi-user Set (multiusr)
Package: User Upgrade (license)
diskette 1 of 1
10. Remove the diskette labeled “UNIX Multi-User Package Installation
Diskette 1 of 1” from the floppy drive.
11. Insert the diskette labeled “User Upgrade (license) diskette 1 of 1” into the
drive.
12. Press to install the software.
The system displays the following message:
Tunable Parameter “NPROC” is currently set to 750.
Is it OK to change it to 200? (y/n)
13. Enter
n
When the process is finished, the system displays the following message:
Installation of <Multi-user set> is completed.
Insert a into Floppy Drive 1.
Type [go] when ready,
or [q] to quit: (default:go)
14. Enter
q
15. Shut down and reboot the system. See “Shutting Down and Rebooting the
Lucent Intuity System” in Chapter 3, ‘‘Common System Procedures’’, for
the procedure.
16. Verify the Multi-User software package installation by accessing the View
Installed Software window.
To access the View Installed Software window, do the following:
a. Starting at the Lucent I
NTUITY Main menu (Figure 10-1), select
ENTER
ENTER
>View Installed Software
>System Verification
> Customer/Services Administration